slic3r.org »

Slic3r Manual

At this stage Slic3r has been configured and a model has been acquired, sliced and made ready for print. Now would be the time to fire up the printer and try it out.

A variety of host software is available to send the G-code to the printer. Amongst the open-source solutions are: Printrun1, Repetier2 and Repsnapper3.

The following sections will cover the options available in expert mode, and look at advanced printing techniques, including special cases and troubleshooting.


  1. https://github.com/kliment/Printrun

  2. http://www.repetier.com/

  3. https://github.com/timschmidt/repsnapper